Press F5 key to activate Isoplane top and then select line command and click anywhere in the drawing area to start your line. The three Isoplanes available for selection are Isoplane top, right and left. You can now select isometric plane for your drawing by pressing the F5 key. Now make sure ortho mode is turned on from the status bar, if it is not turned on then press F8 to turn it on. Click OK to exit drafting settings window. Type DS on the command line and press enter.ĭrafting settings window will pop up from this window select snap and grid tab and make sure Isometric snap radio button is checked. Isometric drawing in AutoCAD 2014 and older versions:Īt first, you need to change your snap settings to isometric.
0 Comments
Leave a Reply. |